Dowco-power-sports Guardian Duster Motorcycle Cover Manuel d'utilisateur télécharger pdf

Installation

Read instructions before using.

Unfold cover. Locate ”FRONT” tag, indicating which

part of the cover goes to the front of the motorcycle.

Starting in the front wheel area, pull down over the

windshield and “tuck” the elastic hem under the

centerline of the wheel.

Working toward the rear of the motorcycle, slide the

cover down the sides, avoiding “snag” points. The

cover should be long enough to allow the elastic

hem to fully wrap below the centerline of the rear

wheel and have a tight fit along the perimeter. Care

should also be taken to avoid placing the material

against hot engine components, as burning or melt-

ing may occur.

Caution: Mirrors, muffler ends, shifters, brakes and

foot pegs are common wear points. Do not allow

fabric to “snag” around them. Antennas are capable

of puncturing the cover – use extreme care.

Important

Wait for the motorcycle to cool-down before

installing the cover. This will greatly increase the life

of your cover. Grommet patches are provided to

enable you to secure the cover under the

motorcycle.

Care and Cleaning

Your cover requires very little maintenance. Normal

dirt and grime should be brushed off with a soft terry

cloth or removed with warm water and a mild

detergent using a sponge or terry cloth. The cover

should be thoroughly dried before using.

Caution: Do not place in washing machine and do

not wring or twist the cover to remove moisture.

Important

Failure to comply with the above directions may

reduce the life of your cover. If you have any

questions or comments, please contact either your

dealer or DOWCO Inc.

Congratulations on your purchase of a GUARDIAN

DUSTER

™

motorcycle cover. Properly cared for, your

cover will last for many years of service. The GUARDIAN

DUSTER

™

cover is manufactured from 100%

cotton fabric and is intended for indoor storage only. Your cover also contains an elastic shock cord that is

sewn into the hem. This feature keeps the cover tight around the wheels. The following information should

be used to ensure maximum longevity.

Note: All GUARDIAN

DUSTER

™

covers are sized to fit specific motorcycles. It is very important that you

have the correct one for your application. If you are uncertain that your GUARDIAN

DUSTER

™

cover is

correct, please contact your dealer or DOWCO Inc. to verify your fit before attempting first-time use.

Note: This cover is not designed for covering your motorcycle while it is outdoors, being

trailered or in the back of a pick-up truck.

INSTRUCTIONS FOR THE INSTALLATION OF

GUARDIAN

DUSTER

™

MOTORCYCLE COVER

Form # 00079

Revised 04/04

Printed in China

This cover must be completely removed prior to starting

or operating the vehicle. Failure to do so could result in

serious injury and/or property damage.

4230 Clipper Drive Manitowoc, WI 54220 U.S.A.

Phone: (800) 558-7755 - Fax: (920) 682-5891

Visit our Web Site! - www.dowco-inc.com

Résumé du contenu

Page 1 - Printed in China

InstallationRead instructions before using.Unfold cover. Locate ”FRONT” tag, indicating whichpart of the cover goes to the front of the motorcycle.Sta

Commentaires sur ces manuels

Pas de commentaire

Dowco-power-sports Guardian Duster Motorcycle Cover Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Sports et loisirs Dowco-power-sports Guardian Duster Motorcycle Cover. Dowco Power Sports Guardian Duster Motorcycle Cover User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Sports et loisirs Dowco-power-sports Guardian Duster Motorcycle Cover